Panasonic KX-TDA100D

Feature
Default
Type 1
(with )
Type 2
(without )
Hot Line programme/set/cancel 740 740
Absent Message set/cancel 750 750
BGM set/cancel 751 751
Remote Wake-up Call 76 76
Timed Reminder set/cancel 760 760
Printing Message 761 761
Extension Dial Lock set/cancel 77 77
Time Service Switch 780 780
Remote Extension Dial Lock off 782 782
Remote Extension Dial Lock on 783 783
NDSS Monitor Release 784 784
Trunk Busy Out Clear 785 None
Extension Feature Clear 790 790
Extension Personal Identification Number (PIN) set/cancel 799 799
Dial Information (CTI) None None
Other PBX Extension Number (TIE) 1–16 None None
Quick Dialling
*1
None None
*1
It is possible to register Quick Dialling numbers that overlap with other registered numbers. This is used for Automatic Rerouting
of Calls via a Private IP Network to Public Trunks.
2. Flexible Numbering (available while a busy, DND, or ringback tone is heard)
Feature numbers which are available while a busy, DND, or ringback tone is heard can be customised for
easy use. The numbers should be one digit ("0" through "9", " ", or "#") and must not conflict. For default,
refer to the following table:
[Flexible Numbering Table (available while a busy, DND, or ringback tone is heard)]
Feature
Default
Call Waiting/DND Override 1 or 2
*1
Executive Busy Override 3
Message Waiting set 4
Call Monitor 5
Automatic Callback Busy/CCBS 6
Alternate Calling—Ring/Voice
*1
To use Call Waiting/DND Override, both "1" and "2" are available by default.
Feature Guide 399
2.3.6 Flexible Numbering/Fixed Numbering