2.7 [1] Configuration
178 PC Programming Manual
Feature Manual References
None
CO Pulse Speed
Selects the speed at which pulse dials are sent to the T1 channel.
Default
10 pulse/s
Value Range
10 pulse/s, 20 pulse/s
Maintenance Console Location
2.7.17 [1-1] Slot—T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
1.4.2 Dial Mode Selection
Wink Signal Time Out
Specifies the length of time that the PBX waits to receive a wink signal after seizing a CO line. If a
wink signal is not received before this timer expires, the CO line is released.
Default
1024 ms
Value Range
64 × n (n=1–128) ms
Maintenance Console Location
2.7.17 [1-1] Slot—T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
None
Start Signal Type
Selects the type of the start signal.
Default
Wink
To Next Page
Loading...
