2.3 Connect
PC Programming Manual 35
2.3.4 Connect—Modem
Connects to the PBX in Interactive mode through the modem.
To access the PBX remotely using this feature, an RMT card must be installed and the Remote—
Analog Remote (Modem) Floating Extension Number assigned in 2.17.1 [11-1] Main.
This option allows direct entry of connection parameters, for cases where the PC is used to connect
to one or just a few PBXs, and an individual profile for each PBX is not necessary. If you connect to
multiple PBXs and would prefer to choose from among pre-saved profiles instead, see 2.3.5
Connect—Profile Setup for more details about creating profiles.
To connect to the PBX by Modem
1.
From the Connect menu, select Modem.
The Login window will be displayed.
2. Select a connection option.
• Select the Use profile check box if you want to use a pre-saved profile.
a. Select the profile to use from the drop-down list.
The Setup button will become unavailable.
b. If the system password for the PBX has not been stored with the profile, enter it.
If the system password has been stored with the selected profile, it does not need to be
entered.
• Confirm that the Modem radio button is selected if you want to enter parameters manually.
a. Click Setup.
b. Modify the connection parameters as required. For more details, see the table below.
c. Click OK.
3. Click OK.
Connection Settings for LAN
Setting Values Explanation
IP Address 1.0.0.0–
223.255.255.255
Specify the IP address of the PBX on the LAN.
Enter the same IP address that was input in IP
Address of 2.7.28 [1-1] Slot—CTI-LINK Card
Property (KX-TDA100/KX-TDA200/KX-
TDA600 only).
Port Number 10000–65535 Specify the port number used to access the
PBX via LAN. Enter the same port number that
was input in Maintenance Port Number of
2.7.28 [1-1] Slot—CTI-LINK Card Property
(KX-TDA100/KX-TDA200/KX-TDA600 only)
or 2.7.19 [1-1] Slot—IP-GW Card Property
(KX-TDA50 only).
To Next Page
Loading...
