Panasonic KX-TDA50

2.15 [9] Private Network
PC Programming Manual 635
Default
3
Value Range
0–10
Maintenance Console Location
2.15.2 [9-2] Network Data Transmission
Programming Manual References
2.15.1 [9-1] TIE Table—Enhanced QSIG Call Information (Optional SD Card Required)
Feature Manual References
1.13.14 Private Network Features—Centralized Voice Mail
Network MSW Data Transmission for Centralized VM Feature—Data Re-
transmission : Repeat Timer
Specifies the length of time between repeated re-transmission of network message waiting
notifications.
Default
30 s
Value Range
10–240 s
Maintenance Console Location
2.15.2 [9-2] Network Data Transmission
Programming Manual References
2.15.1 [9-1] TIE Table—Enhanced QSIG Call Information (Optional SD Card Required)
Feature Manual References
1.13.14 Private Network Features—Centralized Voice Mail
2.15.3 [9-3] Network Operator (VoIP)
This screen allows network operators to be programmed. A network operator is an extension at a
remote PBX that will monitor other PBX extensions using Network Direct Station Selection (NDSS).
The settings on this screen should be programmed at the PBX that is to be monitored (Network BLF
Data Transmission for Centralized Operator Feature—Network PBX ID 2–8). Up to 8 network
operators can be programmed.