Panasonic KX-TDA50

2.12 [6] Feature
608 PC Programming Manual
Programming Manual References
2.8.3 [2-2] Operator & BGM
Feature Manual References
1.12.5 Operator Features
1.17.3 Tenant Service
ARS Mode
Specifies the ARS mode used when making a CO line call.
Default
Same as System Setting
Value Range
Off: ARS is disabled.
On for Local Access Operation: ARS operates when an extension user makes a call using any Idle
Line Access method.
On for Any CO Access Operation: ARS operates when an extension user makes a call using any CO
Line Access method.
Same as System Setting: The setting specified in ARS Mode in 2.14.1 [8-1] System Settings is
applied.
Maintenance Console Location
2.12.6 [6-6] Tenant
Programming Manual References
2.14.1 [8-1] System Settings
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
1.17.3 Tenant Service
System Speed Dial
Specifies which system speed dialing table is used by the tenant. This setting is only available when
an MEC (KX-TDA50/KX-TDA100/KX-TDA200) or EMEC (KX-TDA600) card is installed.
Default
For KX-TDA50:
Basic Memory
For KX-TDA100/KX-TDA200/KX-TDA600:
Same as System Setting
Value Range
For KX-TDA50:
Basic Memory: PBX basic system speed dialing numbers are used.