2.3 Connect
PC Programming Manual 33
2.3 Connect
2.3.1 Connect—RS-232C
Connects to the PBX in Interactive mode through the serial RS-232C interface of the PBX.
This option allows direct entry of connection parameters, for cases where the PC is used to connect
to one or just a few PBXs, and an individual profile for each PBX is not necessary. If you connect to
multiple PBXs and would prefer to choose from among pre-saved profiles instead, see 2.3.5
Connect—Profile Setup for more details about creating profiles.
To connect to the PBX by RS-232C
1.
From the Connect menu, select RS-232C.
The Login window will be displayed.
2. Select a connection option.
• Select the Use profile check box if you want to use a pre-saved profile. This option is only
available when one or more profiles have been previously stored.
a. Select the profile to use from the drop-down list.
The Setup button will become unavailable.
b. If the system password for the PBX has not been stored with the profile, enter it.
If the system password has been stored with the selected profile, it does not need to be
entered.
• Confirm that the RS-232C radio button is selected if you want to enter the parameters
manually.
a. Click Setup.
b. Specify the settings as required. For more details, see the table below.
c. Click OK.
3. Click OK.
2.3.2 Connect—USB
Connects to the PBX in Interactive mode through the USB port on the PBX, or a USB port (USB
Module) attached to a DPT.
Connection Settings for RS-232C
Setting Values Explanation
Port COMx Specify the number of the COM port assigned
to the PC's RS-232C interface. Only available
COM ports are displayed.
Baud Rate (bps) 2400bps, 4800bps,
9600bps, 19200bps,
38400bps, 57600bps,
115200bps
Specify the speed of data transmission.
To Next Page
Loading...
