2.1 Introduction
PC Programming Manual 19
a. Enter the system password for the PBX.
b. Click Setup.
c. Specify the settings as required. For more details, see the tables below.
d. Click OK.
3. Click OK.
Maintenance Console will start, and automatically connect to the PBX. If this is the first time that
Maintenance Console has connected to the PBX, and the date and time of the PBX have not yet
been set, the Quick Setup wizard will run. For more details, see Starting the KX-TDA
Maintenance Console and Assigning the Basic Items (Quick Setup).
Connection Settings for RS-232C
Setting Values Explanation
Port COMx Specify the number of the COM port assigned
to the PC's RS-232C interface. Only available
COM ports are displayed.
Baud Rate (bps) 2400bps, 4800bps,
9600bps, 19200bps,
38400bps, 57600bps,
115200bps
Specify the speed of data transmission.
Connection Settings for Modem
Setting Values Explanation
Dial Number 1-9, 0, *, #, "," [comma],
T, P, W *
1
Enter the telephone number to be dialed to
access the PBX.
T: Converts the Dial Type from Pulse to Tone.
"," [comma], P, W: Inserts a pause.
Dial Type Auto(Tone),
Auto(Pulse), Manual
Specify the outgoing dialing method.
If Manual is chosen, dialing must be done with
a connected telephone.
Comment – Enter a comment to identify the set of values.
Port COMx Specify the number of the COM port assigned
to the PC's modem interface.
Only available COM ports will be displayed.
Baud Rate 1200bps, 2400bps,
4800bps, 9600bps,
19200bps, 38400bps
Specify the speed of data transmission.
Modem Initialize – Enter the modem initialize command, and click
Initialize to send the command to the modem.
For more details, refer to your modem's
instruction manual.
*
1
:
T, P and W can only be entered when using MPR Software File Version 3.2000 or later.
To Next Page
Loading...
