2.8 [2] System
PC Programming Manual 241
Programming Manual References
None
Feature Manual References
1.3.16 Conference
Miscellaneous
Caller ID—Waiting to receive
Specifies the length of time that the PBX waits to receive Caller ID from an analog CO line. If the
Caller ID is received through an analog CO line card on which no Caller ID card is mounted or through
a port to which Caller ID Detection is disabled, this timer is not applicable.
Default
5 s
Value Range
0–15 s
Maintenance Console Location
2.8.4 [2-3] Timers & Counters
Programming Manual References
2.12.1 [6-1] System Speed Dial
2.12.2 [6-2] Caller ID Modification
Feature Manual References
1.3.1 Caller ID
Caller ID—Visual Caller ID Display
Specifies the length of time that a Caller ID number, with the Call Waiting tone offered by an analog
line from the telephone company, is shown on the display. The Caller ID number flashes on the display
for five seconds, followed by a 10-second pause, then flashes again for five seconds.
Default
30 s
Value Range
0–250 s
Maintenance Console Location
2.8.4 [2-3] Timers & Counters
Programming Manual References
None
To Next Page
Loading...
