Panasonic KX-UT133

5.4.4 IEEE 802.1X Settings (KX-UT248 only)
IEEE8021X_ENABLE
Value Format Boolean
Description Selects whether to use the IEEE 802.1X protocol.
Note
• This setting is available only when "NW_SETTING_ENABLE" is
set to "
N".
• You should specify "Y" for only one of "LLDP_ENABLE",
"VLAN_ENABLE", or "IEEE8021X_ENABLE".
If "Y" is specified for two or more of the parameters above, the
settings are prioritized as follows: IEEE8021X_ENABLE >
VLAN_ENABLE > LLDP_ENABLE. Therefore, if "Y" is specified
for both "VLAN_ENABLE" and "LLDP_ENABLE", the
VLAN-related settings are used.
Value Range
• Y (Enable)
• N (Disable)
Default Value
N
Web User Interface Reference Enable IEEE802.1X (Page 86)
IEEE8021X_AUTH_PRTCL
Value Format Integer
Description Specifies the authentication method used with the IEEE 802.1X
protocol.
Note
• This setting is available only when "VLAN_ENABLE" is set to
"
N".
Value Range
• 1 (PEAP)
• 0 (EAP-MD5)
Default Value 0
Web User Interface Reference Authentication Protocol (Page 87)
IEEE8021X_USER_ID
Value Format String
198 Administrator Guide Document Version 2013-03
5.4.4 IEEE 802.1X Settings (KX-UT248 only)