Panasonic KX-UT133

RINGBACK_TONE_GAIN
Value Format Integer
Description Specifies the gain, in decibels, of the ringback tone.
Value Range -24–6
Default Value 0
RINGBACK_TONE_RPT
Value Format Integer
Description Specifies whether the ringback tone is repeated.
Value Range 0–1
– 0: No Repeat
– 1: Repeat
Default Value 1
RINGBACK_TONE_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of ringback tones using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 60 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 60,2000,3940
Web User Interface Reference Tone Timings (Page 138)
HOLD_ALARM_FRQ
Value Format Comma-separated Integer
Description Specifies the dual-tone
frequencies,
in hertz, of the hold alarm using 2
whole numbers separated by a comma.
Value Range 0, 200–2000 (0: No tone)
Default Value 425
Document Version 2013-03 Administrator Guide 217
5.5.2 Tone Settings