Panasonic KX-UT133

Value Range
• Auto Negotiation
• 100 Mbps/Full Duplex
• 100 Mbps/Half Duplex
• 10 Mbps/Full Duplex
• 10 Mbps/Half Duplex
Note
• The KX-UT248
supports Gigabit Ethernet. When connecting to
a network that supports Gigabit Ethernet, select [Auto
Negotiation].
Default Value Auto Negotiation
4.3.2.2 LLDP Settings
Enable LLDP
Description Selects whether to enable or disable sending and receiving LLDP
frames.
Note
• You should specify "Yes" for only one of "LLDP", "VLAN" or
"IEEE8021X".
• If "Yes" is specified for two or more of the parameters above,
the settings are prioritized as follows: "
IEEE8021X" > "VLAN"
> "LLDP". Therefore, if "Yes" is specified for both "VLAN" and
"LLDP", the VLAN-related settings are used.
Value Range
• Y (Enable)
• N (Disable)
Default Value Y
Configuration File Reference LLDP_ENABLE (Page 204)
LLDP-MED Interval timer
Description Specifies the interval, in seconds, between sending each LLDP frame.
Value Range 1–3600
Default Value 30
Configuration File Reference LLDP_INTERVAL (Page 204)
IP Phone (VLAN ID)
Description Indicates the VLAN ID of the phone using LLDP (reference only).
Value Range 1–4094
Default Value Not applicable.
Document Version 2013-03 Administrator Guide 83
4.3.2 Ethernet Port Settings