Panasonic KX-UT133

HOLD_TONE_RPT
Value Format Integer
Description Specifies whether the hold tone is repeated.
Value Range 0–1
– 0: No Repeat
– 1: Repeat
Default Value 1
HOLD_TONE_TIMING
Value Format Comma-separated Integer
Description Specifies the pattern, in milliseconds, of the hold tone using up to 10
whole numbers (off 1, on 1, off 2, on 2…) separated by commas.
Note
• It is recommended that you set a value of 500 milliseconds or
more for the first value (off 1).
Value Range 0–16000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 500,190,190,190,2890
BELL_CORE_PATTERN1_TIMING
Value Format Comma-separated Integer
Description Specifies the cadence, in milliseconds, of pattern ID 1, described in the
LSSGR, GR-506-CORE, "Signaling for Analog Interfaces
" section 14,
using up to 8 whole numbers (on 1, off 1, on 2, off 2…) separated by
commas.
Value Range 0–5000 (0: Infinite time)
Note
• Avoid setting 1–50 for any of the values.
Default Value 2000,4000
BELL_CORE_PATTERN2_TIMING
Value Format Comma-separated Integer
220 Administrator Guide Document Version 2013-03
5.5.2 Tone Settings