14. Menu Guide – Entering Characters
610
Entering Characters
Follow the steps below when the character entry screen is displayed.
1
Enter characters.
≥Press 3421 to select characters and then press or
until the character to enter is displayed. (Repeat this)
•
To repeatedly enter the same character, rotate or to the right to
move the entry position cursor.
• If you select an item and press or , you can perform the following
operations:
– [ ]: Change the character type to [A] (upper case characters), [a] (lower
case characters), [1] (numbers), and [&] (special characters)
–[] ]: Enter a blank
– [Delete]: Delete a character
– [ ]: Move the entry position cursor to the left
– [ ]: Move the entry position cursor to the right
• When entering a password, (A) shows the number of characters you have
entered and the number of characters you can enter.
2
Complete entering.
≥Select [Set] and then press or .
(A)
To Next Page
Loading...
Need help?
General
