EasyManua.ls Logo

Panasonic LUMIX DMC-TZ4 - Preparations: Charging the Battery; Battery Charging Process

Panasonic LUMIX DMC-TZ4
342 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Battery
(model- specific)
Chargin 9 battery
I Connect to charger(Ensure 'LUMIX' faces outwards.)
Indoor electrical outlet
(charge at room temperature of
10- 35°C (50°F-g5°F))
Fold out pins and
plug into electrical outlet
light (CHARGE) 1
on:
Off: Charging complete (Disconnect charger and battery when
charging is complete.)
If light is flashing: Charging may take longer than normal if battery temperature is
too high or too low (charging may not be completed).
Battery/charger connector is dirty, Clean with dry a cloth.
IApproximate battery life
(at 30-sec intervals)
(equivalent to approx. 150 [165 _z] rains)
.1 Values based on CIPA standards. (P.99)
Number reduced if intervals longer - approx. 75 [82 -.*z]pictures if 2-minute intervals
Above figures may be reduced if intervals between recordings are longer; if flash, zoom,
or LCD MODE are used frequently; or in colder climates (depends on actual usage).
2DMC-TZ4
@ Battery will be warm during charging and for some time thereafter.
@ Battery will run out if not used for long periods of time, even after being charged,
@ Frequently charging up battery is not recommended.
(Frequently charging battery reduces maximum usage time and can cause battery to expand.)
@ Do not disassemble or modify the charger.
@ If available battery power is significantly reduced, battery is reaching end of lifespan. Please
purchase a new battery.
@ For your safety and to prevent damage to this camera, do not attempt to operate this camera with
any non-Panasonic "after-market" brand battery.
6 VQT1 P79

Table of Contents

Related product manuals