Chapter 6 Maintenance — Troubleshooting
152 - ENGLISH
Problems Points to be checked Page
Cannot control the
projector with Art-Net.
f Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f Is [Art-Net SETUP] set to other than [OFF]? 124
f Are [NET], [SUB NET], [UNIVERSE], and [START ADDRESS] set correctly? 124
The DIGITAL LINK input
image is not displayed.
f Is the cable compatible to the condition of the projector used? 37
f Are the connections between the twisted-pair-cable transmitter and an external
device, and between the twisted-pair-cable transmitter and projector correctly done?
―
f Is [DIGITAL LINK MODE] set to [AUTO] or [DIGITAL LINK]? Is it set to
[ETHERNET]?
122
f Is a signal which is not compatible with a twisted-pair-cable transmitter being input? ―
Attention
f If problems persist even after checking the preceding points, consult your dealer.
To Next Page
Loading...
