Panasonic PT-RZ570

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 45
Note
f In the factory default setting, the time zone of the projector is set to +09:00 (Japan and Korea Standard Time). Change the setting of the
[PROJECTOR SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.
Initial setting (date and time)
Set the local date and time. After completed the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [DATE AND TIME].
To set the date and time automatically, refer to “Setting the date and time automatically” (x page 110).
1) Press as to select an item.
20XX
6/6
1
1
12
34
56
MONTH
DAY
HOUR
MINUTE
SECOND
Please set the date and time of the built-in clock of the
projector.
INITIAL SETTING
SET
CHANGEMENU SELECT
YEAR
ENTER
2) Press qw to switch the setting.
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
2)
3)
6)
4)
2)
7) 9)
1) 8)
3)
5)
1) Turn the focus ring to roughly adjust the focus of the projected image. (x page 48)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 30)
f Refer to “Navigating through the menu” (x page 57) for the operation of the menu screen.
3) Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<HDMI 1> button, <HDMI 2> button, <DIGITAL LINK> button, <COMPUTER 1/2> button, <VIDEO> button,
<DVI-D> button
Control panel:
<INPUT SELECT> button
f For details of operation for input selection, refer to “Selecting the input signal” (x page 47).
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 33)