Chapter 3 Basic Operations — Switching on/off the projector
46 - ENGLISH
5) Adjust the position of the projected image by operating the lens shift lever.
6) If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
7) Turn the zoom ring to adjust the size of the projected image to match the screen.
8) Adjust the focus again with the focus ring.
9) Adjust the zoom again with the zoom ring to adjust the size of the projected image to match the
screen.
Note
f When the projector is switched on for the rst time after purchase, as well as when the [PROJECTOR SETUP] menu → [INITIALIZE] →
[ALL USER DATA] is executed, the [INITIAL SETTING] screen is displayed after projection starts. Refer to “When the initial setting screen is
displayed” (x page 42) for details.
Switching off the projector
1)
2)
1)
4)
3)
2)
1) Press the power <v/b> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks in red.
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f For approximately ve seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f Even when the power <v/b> button is pressed and the projector is switched off, the projector consumes power if the main power
of the projector is on.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is restricted,
but the power consumption during standby mode can be conserved.
f While projecting, the power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reected.
To Next Page
Loading...
