DOC-0017-04-EN: AC20 Series - Hardware Installation Manual
10 (154) DOC-0017-04-EN-A 22.03.2023
4 Introduction
4.1 About this Hardware Installation Manual
Users
This Manual is intended for use by the installer of the AC20 series Inverters. It assumes a reasonable level
of understanding in this discipline.
There is a separate Software Reference Manual – DOC-0017-13 “AC20 Series – Software Reference
Manual”, that is intended for use by the user and programmer of the AC20 series Inverters.
Manual Organisation
This Hardware Installation Manual is organised into chapters, indicated by the numbering on the edge of
each page.
If the manual is to be printed, it is designed so that it should be printed double-sided using the long-edge for
binding.
The Manual is ordered in a sequence that takes the user through the product installation process, resulting
in the basic operation of the drive.
Information for the full AC20 product is referred to as “the Inverter” or “drive” throughout the manual.
Product coding: Any “x” within a product code indicates there are variants. See ‘Chapter 12: AC20 Series
Product Codes’ section for more information.
Manual Revision
This revision replaces all previous revisions of this document. Parker has made every effort to ensure that
this document is complete and accurate at the time of printing. In accordance with our policy of continuous
product improvement, all data in this document is subject to change or correction without prior notice.
4.2 Before You Start…
Equipment Inspection
At the point of receipt of your product, check:
- For signs of transit damage.
- That the product code on the box label matches your order.
Equipment Storage
If the product is not being installed immediately, store the unit:
- In a well-ventilated place.
- Away from high temperatures and humidity,
- Away from dust or metal particles.
Storage Temperature:
Shipping Temperature:
To Next Page
Loading...
Need help?
General
