Parker AC20 Series - Digital Output; Reference Voltage Output

DOC-0017-04-EN: AC20 Series - Hardware Installation Manual
146 (154) DOC-0017-04-EN-A 22.03.2023
Digital Output
Terminal Idents:
DX11, referenced to 0V
Nominal Output Voltage:
22V
Minimum Output
Voltage:
18V @ 50mA
Maximum Output
Current:
50mA
Note: Total consumption of all Base Control Board Digital Outputs DX1,
DX2, DX3, User +24V Output, and Option Card DX11 must not exceed
120mA.
Isolated:
No
Short Circuit Protection:
Yes
+10V Reference Voltage Output
Terminal Idents:
+10V, referenced to 0V
Maximum Output
Current:
± 10mA
Accuracy:
10V ±360mV (Typically 150mV)
Isolated:
No
Over Current Protection:
Yes
Note: If there is a short circuit on the +10V reference output, the -10V
supply will collapse.
-10V Reference Voltage Output
Terminal Idents:
-10V, referenced to 0V
Maximum Output
Current:
± 10mA
Accuracy:
-10V ±560mV (Typically 200mV)
Isolated:
No
Over Current Protection:
Yes
Note: If there is a short circuit on the -10V reference output, the +10V
supply will still be active.