Peak PCAN - Lan

PCAN-Ethernet Gateway FD DR – User Manual
51
By clicking on the Save Settings button you can save your
previously defined bit rates.
5.5.2 LAN
The
Network > LAN page displays the current settings of the LAN
interface and provides options for configuration.
LAN Interface
In this box the settings of the LAN interface will be displayed. IP
address, Subnet mask, and gateway are adjustable. The MAC
address cannot be changed. Each device receives a unique MAC
address during the manufacturing process, which can be used for
identification.
LAN Address Settings
The LAN interface can be configured by using the form underneath
the general information overview. Settings can be saved by clicking
the Save Settings button located below the form.
DHCP: If the IP network uses DHCP (Dynamic Host Configuration
Protocol), the PCAN-Gateway IP address, Subnet mask, and
gateway address are assigned automatically. Otherwise, you must
manually enter the information. Switch DHCP on if required
(Enable).
Note: DHCP is not recommended, because it is necessary to
know the IP address of the PCAN-Gateway to access the
configuration website. Furthermore the IP address may change
after a restart of the device or the DHCP server. In this case the
existing routes won't work.
IP Address: Enter the IP address (IPv4) of the LAN interface. It
should be noted that only values from 0 to 255 may be used and
certain address ranges are reserved.