5.1.3. Displayed icons (symbols) and messages in RCD function
Indicates the correct input terminal connectivity .
The user should connect the test leads to the
appropriate terminals.
Indicates L connection is connected on the N
input terminal and vice-versa
Indicates no connection on the PE input terminal
If the wiring condition is other than normal, the Tester is limited on its measurements that can be
performed.
Notes:
1) Will not detect two hot wires in a circuit.
2) Will not detect a combination of defects.
3) Will not detect reversal of grounded and grounding conductors.
Indicates the battery status
Indicates high temperature and therefore cannot make any
measurements
Appears during the auto test when rcd has operated on the x ½ test
Appears during the manual test when rcd has operated on the x ½ test
Appears when UF voltage exceeds the previously set UL voltage. (UL
voltage can be set to 25V or 50V) The user must check the impedance
between L-PE
To Next Page
Loading...
