P350 Operation Manual 42
Set-Up
CAUTION! Failure to follow this procedure may result in severe damage to the crawler and camera system
Straps Assembly:
If using a P354 crawler or a P356 crawler without the Large Manual Elevator you must fit the crawler strap. Using 2
(P354) × M4 x 6 SKT CAP SS or 4 (P356) × M6 x 8 SKT CAP SS screws (supplied), secure the strap to the crawler
body, fig 4.3; the recommended torque for the M4 x 6 screws is 2.4Nm / 21.2 In-Lbs or 8.0Nm / 70 In Lbs for the M6 x
8 screws.
Figure 4.3: Strap Assembly
CAUTION! Do not over-tighten the screws
To Next Page
Loading...