Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
46 / 110 Ref. MKT-IM-012 / D - 03.02.2022
6 Programming
6.1 Display
1. Hourglass Displayed when the motor is running. The camshaft should be
turning.
2. Cursor These cursors appear next to the item that is currently
displayed.
3. Days of the week Displayed days of the week. The flag below the day appears
when that day has been programmed as a day the system
should regenerate (used with 7-day timer programming).
4. Locked/unlocked indicator This symbol is display in basic programming when the current
parameter is locked-out.
It is also used in advanced programming to indicate if the
displayed parameter is locked when the controller is in basic
programming (the icon flashes).
5. Colon Colon flashes as part of the time display.
It also indicates normal operation (742 only).
6. Indicator Indicator for day regeneration programming.
7. Cursor This cursor is displayed when the days between regeneration
are being programmed (used with 0.5 to 99 day regeneration
programming).
8. Cursor One of these cursors is displayed to indicate which day is
programmed into the controller.
To Next Page
Loading...
