EasyManuals Logo

Pentair AUTOTROL LOGIX 742 User Manual

Pentair AUTOTROL LOGIX 742
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Installer manual Autotrol Magnum 293 - 298 Logix 742-762 - Programming
62 / 110 Ref. MKT-IM-012 / D - 03.02.2022
6.4.7 Resetting the controller
Info
Resetting the controller will delete all information stored in its memory, except the
time and day.
This will require you to reprogram the controller completely from the initial power-up
mode.
Resetting the controller:
1. Press and hold the and for 5 seconds.
ð H0 and the system’s set resin volume (or “F” mode) will be displayed.
2. If a history value other the “H0” is displayed, use to scroll through the settings until “H0”
is displayed.
3. To reset the controller, press and hold for 5 seconds.
ð The controller will be reset to an unprogrammed state.
4. Go to Programming [
Page46], to reprogram the controller.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pentair AUTOTROL LOGIX 742 and is the answer not in the manual?

Pentair AUTOTROL LOGIX 742 Specifications

General IconGeneral
BrandPentair
ModelAUTOTROL LOGIX 742
CategoryControl Unit
LanguageEnglish

Related product manuals