Installer Manual Foleo - Programming
Ref. MKT-IM-038 / C - 15.11.2019 41 / 112
17. USB connect → Allows you to connect the controller to a PC via a USB cable
for field programming or download of diagnostic
parameters via PC (Field Programmer application
required).
18. Arrows → Displayed in the upper-left and upper-right corners of the
screen, these arrows allow you to navigate from one screen
to another.
→ Allow you to change the values of certain settings when
programming the controller.
NOTE
Settings on previous screen are not saved unless is pressed.
19. Alarm → Displayed when an error has occurred; accompanied with an
audible alarm. Press to silence the audible alarm.
20. Error → Displayed when an error has occurred. Press to display the
error screen for more detailed error information.
21. Error log → Press to show error list with date and time.
22. Advance → This arrow allows you to advance through cycle steps during
a regeneration.
23. Reset → Displayed in the diagnostics screen by pushing on totalizer
and peak flow buttons to reset totalizer and peak flow data,
and in master settings screen to reset parameters to
factory or non-factory settings.
24. Non-factory
settings
→ Press to save all the configuration in a custom profile.
25. Brightness → Displays the brightness screen, to adjust the backlight
brightness of the controller screen.
To Next Page
Loading...
