Installer Manual Foleo - Programming
Ref. MKT-IM-038 / C - 15.11.2019 53 / 112
NOTE
Degree hardness units are converted to ppm upon input. Degree inputs may be rounded up
or down to the nearest ppm equivalent.
Press the screen navigation arrows at the upper-right and left of the screen to navigate to the
assistance name, assistance phone, and assistance interval screens. See 5.2. Quick program guide,
page 42 for more information about these settings.
Press to save changes or press to return to the master setting screen without saving.
5.4.2. USB connection for field programming
The XTR features a USB port that allows you to connect a PC to the controller for field programming
and diagnostic parameter download.
NOTE
Field programmer software is required for field programming features. See XTR field
programmer manual for more information on using the field programmer software.
NOTE
Do not remove USB cable from computer or controller while connected and transferring.
From the format screen, press to access the USB screen.
When the USB screen appears, connect a USB cable to the USB port on the controller circuit board
(see 4.5.10. Electrical connection, page 38 for location of USB port). Connect the other end of the USB
cable to a PC with the field programmer software installed and follow the directions in the XTR field
programmer manual to complete the connection.
Press to return to master settings.
USB
Connect the usb cable to the
control and PC and start
the field programming
application
To Next Page
Loading...
