Installer Manual Foleo - Maintenance
80 / 112 Ref. MKT-IM-038 / C - 15.11.2019
8.5.4. Injector and injector screen cleaning
No. Operation
A
Remove the softener cover, see 8.5.1. First steps, page 76 and 8.5.2. Softener cover
removal, page 77.
B Remove the injector cap screws (3).
C Remove the injector cap (2).
D Remove the seal (4) taking note of its position.
E Using the injector puller (1), remove the injector (5).
CAUTION
To avoid any damage on the injector, use only the dedicated puller to remove it.
F Remove the screen (6).
G Clean or change the injector (5), the screen (6) and the seal (4).
H
Lubricate all seals with approved P-80
®
Emulsion lubricant only.
CAUTION
Using another type of lubricant, such as petroleum-based lubricants (Vaseline, oils, or
hydrocarbon-based lubricants) or silicone grease, may damage the valve.
I Reverse above procedure steps to rebuild.
To Next Page
Loading...
