Pentair FOLEO 5800 XTR - Troubleshooting; Controller; Alarm Detection; Alarm Alerts

Installer Manual Foleo - Troubleshooting
94 / 112 Ref. MKT-IM-038 / C - 15.11.2019
9. Troubleshooting
9.1. Controller
9.1.1. Alarm detection
If an error in valve or controller function occurs, an alarm will sound and the home screen will display
the error alert button and the alarm button .
Press the alarm button to mute the alarm.
Press the error alert button to view information about the error.
If the display is in sleep mode when an error occurs, the screen will turn on for five minutes. The
controller will beep once every 10 seconds until the error is cleared. If the error is not cleared after
five minutes, the screen will switch to power saving mode and display the error alert button as a
screen saver.
9.1.2. Alarm alerts
NOTE
An error alert appears on the home screen if an error condition is detected. Press the error
alert button to view the error message.
NOTE
Most error alerts are cleared at regeneration. If the error persists following a regeneration
attempt the appropriate reset and recovery procedure below or contact technical support.
Water treatment
wed
12:01 am
2 d
treatment
rapid rinse
backwash
tank refill
pause
draw