Installer Manual Foleo - Programming
Ref. MKT-IM-038 / C - 15.11.2019 63 / 112
5.4.11. Non-factory setting
After all parameters in master setting have been set, press on the master settings screen to
display the non-factory settings screen.
Press to save all programmed master settings parameters to non-factory settings. At any point,
the controller can be reset to these saved custom settings (see 5.5.1. Error log, page 65). Press to
return to the master settings screen without saving.
NOTE
By performing a non-factory reset, any setting that is subsequently programmed without
saving to non-factory settings will be reset to the previously saved non-factory settings in
the controller.
5.5. Diagnostics
The controller records and displays a variety of diagnostic data to assist with troubleshooting
performance issues and fine-tuning system efficiency.
From the master settings or home screens, press the diagnostics button to access the diagnostics
screen.
Non-factory settings
current settings will
be saved as
the non-factory settings?
Diagnostics
peak flow
totalizer
5.7
Lpm
flow rate
9.2
Lpm
153
L
To Next Page
Loading...
