What causes a Pentair Water Dispenser brine tank to overflow?
If your Pentair Water Dispenser's brine tank is overflowing, it could be due to a couple of reasons. First, it might be caused by an improper drain control for the injector. Using a small drain control with a larger injector will reduce draw rates. Another potential cause is a drain control clogged with resin or other debris, so you should clean the drain control.
What does error E3 mean on my Pentair Water Dispenser?
If your Pentair Water Dispenser displays an "E 3" error, it indicates that the controller isn't detecting the camshaft position and is returning to the service position. Wait until the controller returns to the service position. If the camshaft is not turning during the "E 3" display, check if the motor is connected, verify that the motor wire harness is connected to both the motor and the controller module, verify if the optical sensor is connected and in place and verify if the motor gear has engaged the camshaft. If the camshaft is turning more than 5 minutes to find Home position, verify if the optical sensor is in place and connected to wire and inspect for debris in the camshaft slots.
What does E2 error mean on Pentair Water Dispenser?
If your Pentair Water Dispenser is showing an "E 2" error, it means the controller power doesn't match 50 or 60 Hz. Try disconnecting and reconnecting the power. If the problem persists, you may need to replace the controller and/or AC transformer.
General| Brand | Pentair |
|---|---|
| Model | Riversoft |
| Category | Water Dispenser |
| Language | English |
To Next Page
