Installer Manual Riversoft - Maintenance
60 / 90 Ref. MKT-IM-045 / A - 13.03.2020
8.3. Adding salt
TIP
Scan this QR code to download the Salt Reminder application from Pentair in order to
ensure refilling the salt in the brine tank when required.
TIP
Do no fill the brine tank with too much salt if you are approaching to brine tank cleaning
date.
No. Operation
NOTE
The following procedure describes the steps to be performed for a Riversoft 30 system.
Depending on your softener (4, 8, 15 or 30), the steps may be slightly different but the
principle remains the same.
A
Open the softener lid (3).
If necessary the top protective cover (4) can be fully removed.
B Open the salt lid (2).
C Make sure the brine well (1) is closed by its cap.
D Dump salt in the funnel (5) leaving the brine well (1) uncovered for a minimum of 2 cm.
E Close the salt lid (2).
F
Close the softener lid (3).
If necessary remount the top protective cover (4).
To Next Page
Loading...
