Installer Manual Riversoft - Programming
44 / 90 Ref. MKT-IM-045 / A - 13.03.2020
5. Programming
NOTE
Menus are displayed in a defined and incremental order.
NOTE
After 5 seconds without keypad input, the unit returns to normal operation mode and display
the time of day.
NOTE
Memory retention in case of power failure : the controller stores the time of day without
battery in case of power failure. All others programmed parameters are stored in the non-
volatile (Novram) memory and are stored during power failure. The storage time in the flash
memory is about 99 years.
5.1. Display
1. Digits
Two digits used to display the time, program value or error codes.
2. Flow indicator
The flow indicator blinks ON and OFF when water flow turns the meter.
3. Delayed regeneration
indicator
When this dot is displayed, it means that a delayed regeneration is
programmed.
To Next Page
Loading...
