Installer Manual Riversoft - Programming
Ref. MKT-IM-045 / A - 13.03.2020 49 / 90
5.11. History values
The controller features a review level that displays the operation history of the system. To access
history values :
Note
After 30 seconds without a button press, the controller exists the history table.
5.12. Resetting the controller and system selection (u1 to u4)
All programmed settings with the exception of time of day can be reset. Entering the value “0” will
reset the flash memory to the factory default.
To reset the controller:
A Press and hold and simultaneously for 3 seconds.
→ To view the "H" levels.
B Press to navigate through the table.
→ When the desired code is reached, press to display the
value.
→ Some of the values have four digits. Press to display the
first two digits, then press to display the last two digits.
Code Description Notes
H1 Days since last regeneration Days since last regeneration.
H2 Current day of week 0-6.
H3 Water used today since 02h00 In liter.
H4 Water used since last regeneration
In liters,
max value displayed 9999,
max value stored 65 535.
A0 Average water usage for day 0
A1 Average water usage for day 1
A2 Average water usage for day 2
A3 Average water usage for day 3
A4 Average water usage for day 4
A5 Average water usage for day 5
A6 Average water usage for day 6
A Press and hold and simultaneously for 3 seconds.
→ A small "u" will be displayed in the left digit.
→ The right digit will display the current system setting.
B Press until the "u0" system is displayed.
→ Wait 5 seconds for the setting to be stored into the flash
memory. The display will return to the time of day.
→ The controller has now system 1 setting (default setting).
C Follow the steps of the system selection procedure to select
the desired system setting (5.9. System selection, page 48).
To Next Page
Loading...
