1
Introduction
9
f Green button (M)
Resets the value being adjusted.
Switches to ISO AUTO when adjusting the sensitivity.
g INFO button (G)
Changes the style of the display on the monitor. (p.11, p.15)
h GPS button (4)
Turns the GPS function on or off. (p.72)
i Function dial
Selects the function to change its settings with the setting
dial. (Smart Function, p.19)
j Capture mode selector switch
Switches between A (still picture) mode and C (movie)
mode. (p.39)
k Setting dial
Changes the settings for the function selected with the
function dial.
l AF button (I)
Available for adjusting focus, instead of pressing 0
halfway. (p.51)
m AE Lock button (H)
Locks the exposure value before shooting.
In playback mode, the last JPEG image taken can also be
saved in RAW format. (p.42)
n Rear e-dial (R)
Changes the values for camera settings such as exposure.
(p.45)
You can change the menu tabs when a menu screen is
displayed. (p.21)
You can change camera settings when the control panel is
displayed. (p.20)
In playback mode, use this to magnify the image or display
multiple images at the same time. (p.42, p.77)
o Playback button (3)
Switches to playback mode. (p.42) Press the button again to
switch to capture mode.
p Change AF Point/Card slot switch button (c/d)
Enables changing the focusing area. (p.52)
In playback mode, press this button to switch between the
memory cards inserted in the two slots, SD1 and SD2.
(p.42)
q Four-way controller (ABCD)
Displays the Drive Mode, White Balance, or Custom Image
setup menu. (p.19)
When a menu or the control panel is displayed, use this to
move the cursor or change the item to set.
You can assign a function to B and use it as the Fx2 button
(Y). (p.98)
Press B in single image display of the playback mode to
display the playback mode palette. (p.76)
r OK button (E)
When a menu or the control panel is displayed, press this
button to confirm the selected item.
s MENU button (F)
Displays a menu. Press this button while the menu is
displayed to return to the previous screen. (p.21)
About the Four-way Controller
In this manual, each button of the four-
way controller is indicated as shown in
the illustration on the right.
About the Indicator Lamps
You can set the illumination settings for the Wi-Fi lamp, GPS
indicator lamp, self-timer lamp, and remote control receiver
lamp in [Indicator Lamps] of the D2 menu. (p.100)
To Next Page
Loading...
Need help?
General
