7
Appendix
110
You can perform Catch-in Focus shooting using a manual focus
lens. The shutter is released automatically when the subject
comes into focus.
1 Attach a manual focus lens to this camera.
2 Set [24 Catch-in Focus] to [On] in the E4 menu.
3 Set the autofocus mode to v and set [AF
Mode] to x.
4 Place the camera on a fixed support such as
tripods.
5 Adjust the focus to the position where the
subject may pass and press 0 fully.
When the subject comes into focus at the specified position,
the shutter is released automatically.
The Shake Reduction function operates by obtaining the lens
information such as focal length. Set the focal length when
using a lens that the focal length information cannot be
automatically obtained.
1 Set [26 Using Aperture Ring] to [Enable] in the
E4 menu.
2 Turn the camera off.
3 Attach a lens to the camera and turn the camera
on.
The [Input Focal Length] screen appears.
4 Use AB to set the focal
length.
Press C to select a value from
the list.
When using a zoom lens, select
the actual focal length which the
zoom is set to.
5 Press E.
The camera returns to standby mode.
t Memo
• The focal length setting can be changed in [Input Focal
Length] of the A4 menu.
How to Achieve the Correct Exposure with the Aperture
Ring Not Set to 9
The correct exposure can be achieved by the following
procedures when the aperture ring is not set to 9.
1 Set the mode dial to L.
2 Set the aperture ring to the desired aperture.
3 Press M.
The correct shutter speed will be set.
4 If the correct exposure cannot be achieved, adjust the
ISO sensitivity.
Performing Catch-in Focus Shooting
E4
Setting the Focal Length
A4
35
mm
OK
Input Focal Length
To Next Page
Loading...
Need help?
General
