5
Sharing
88
You can perform tethered shooting to operate the camera with
a computer using the optional “IMAGE Transmitter 2”. Captured
images can be directly saved to the computer.
1 Set [USB Connection] to [PTP] in the D2 menu.
2 Turn the camera off.
3 Connect the camera to a computer using a USB
cable.
Refer to Steps 3 and 4 of “Copying an Image in the Memory
Card” (p.87).
4 Turn the camera on.
5 Start the “IMAGE Transmitter 2” on the
computer.
The “IMAGE Transmitter 2” is started and the computer
recognizes the camera.
u Caution
• When the capture mode selector switch is set to C, tethered
shooting cannot be performed.
t Memo
• For details on the “IMAGE Transmitter 2”, refer to the “User
Guide [Operation]” available at the following site.
http://www.ricoh-imaging.co.jp/english/support/
download_manual.html
This camera has a built-in Wi-Fi function. By directly connecting to a
communication device such as smartphones and tablets via wireless
LAN, the camera can be operated from the communication device
and images can be shared with others via social networks or e-mail.
The Wi-Fi function is disabled when the camera is turned on.
Enable the function using one of the following methods.
• Setting from the menus (p.89)
• Setting with the Smart Function (p.89)
When the Wi-Fi function is enabled,
the Wi-Fi lamp lights up and the 7
(white) icon indicating the wireless
LAN status is displayed on the status
screen and Live View screen. When
8 (gray) is displayed, a connection
with the communication device is not
established correctly.
t Memo
•
Even after the Wi-Fi function is enabled, it returns to an inactive
state when the camera is turned off and on again. Also, when
the camera enters
C
mode, the Wi-Fi function is disabled.
• Auto Power Off is not available while a Wi-Fi connection is
established or images are being transferred. If Auto Power
Off is activated while a connection is not established or during
standby, the Wi-Fi function is disabled. The function is
enabled when the camera recovers from Auto Power Off.
• The Wi-Fi function is disabled during the USB connection.
u Caution
• Do not attempt to use the Wi-Fi function in a location where
the use of wireless LAN devices is restricted or prohibited,
such as on airplanes.
• When using the Wi-Fi function, observe local laws and
regulations governing radio communication.
•
If a memory card with a built-in wireless LAN function (such as an
Eye-Fi card or a Flucard) is used, radio wave interference may
occur. When this occurs, disable the Wi-Fi function of the camera.
Operating the Camera with a Computer
Using the Camera with a
Communication Device
Enabling the Wi-Fi Function
1/
250
1600
F
5.6
99999
99999
To Next Page
Loading...
Need help?
General
