295
Appendix
11
Troubleshooting
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the batteries out and putting
them back in again. When the mirror remains in the up position, take the
batteries out and put them back in again. Then, turn the power on. The
mirror will retract. After these procedures are done, if the camera operates
correctly, it does not require any repairs.
We recommend checking the following items before contacting a service
center.
Problem Cause Remedy
The camera
does not
turn on
Batteries are not
installed
Check if batteries are installed. If not, install
charged batteries.
Batteries are not
installed properly
Check the orientation of batteries.
Re-insert batteries according to the +-
symbols. (p.39)
The battery power is
low
Replace with charged batteries or use the
AC adapter kit K-AC84 (optional). (p.42)
The shutter
cannot be
released
The lens aperture
ring is set to other
than the s position
Set the lens aperture ring to the s position
(p.94) or select [Permitted] in [22. Using
Aperture Ring] of the [A Custom Setting 4]
menu. (p.284)
The built-in flash is
charging
Wait until charging is finished.
There is no available
space on the SD
Memory Card
Insert an SD Memory Card with available
space or delete unwanted images. (p.44,
p.75)
Recording Wait until recording is finished.
The
Autofocus
does not
work
The subject is
difficult to focus on
Autofocus cannot focus well on subjects
that have low contrast (the sky, white walls,
etc.), dark colors, intricate designs, rapidly-
moving objects or scenery shot through a
window or a net-like pattern. Lock focus on
another object located at the same distance
as your subject, then aim at the target and
press the shutter release button fully.
Alternatively, use manual focus. (p.121)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
