Pepperl+Fuchs VBG-ENXK20-DMD-EV - AS-I Master Object

26.9.2013
48
AS-i 3.0 EtherNet/IP+Modbus TCP Gateway
EtherNet/IP interface
10.5 AS-i Master Object
class code: 100 (0x64)
1 instance for each AS-i circuit
attribute
ID
access rule name devicenet data
type
default data
value
100 (0x64) get ec-flags UINT (16-bit)
101 (0x65) get/set hi-flags USINT
102 (0x66) get/set operational mode BOOL
103 (0x67) get LDS (list of detected slaves) ULINT
104 (0x68) get/set LPS (list of projected slaves) ULINT
105 (0x69) get LAS (list of activated slaves) ULINT
106 (0x6A) get LPF (list of peripheral faults) ULINT
107 (0x6B) get/set Store_Actual_Configuration BOOL
108 (0x6C) get/set Store_Actual_Parameters BOOL
109 (0x6D) get/set Change_Slave_Adress UINT
110 (0x6E) get/set Lock push-buttons BOOL
Tab. 10-12.
EC-flags (16-bit)
2
15
2
14
2
13
2
12
2
11
2
10
2
9
2
8
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
DA NSE OV EF – – – Pok OR APF NA CA AAv AAs S0 Cok
Tab. 10-13.
DA (double_address): AS-i duplicate address detection
0: no duplicate address
1: duplicate address
NSE (noise): AS-i noise detection
0: no noise
1: noise fault
OV (overvoltage): AS-i overvoltage detection
0: no overvoltage
1: overvoltage fault
EF (earth_fault): AS-i earth fault detection
0: no earth fault
1: earth fault
PoK (periphery_ok): Periphery is OK
0: Periphery is OK
1: Periphery is not OK
OR (offline_ready: The off-line phase is active
APF (ASi-power_fail): An AS-i power fail is occured
NA (normal_operation_active): The normal operation mode is active
0: normal operation is active
1: normal operation is not active