EasyManuals Logo

Pepwave HD2 User Manual

Pepwave HD2
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #115 background imageLoading...
Page #115 background image
setting.
Inbound IP
Address(es)
This setting specifies the WAN connections and Internet IP address(es) from which the service
can be accessed.
Server IP
Address
This setting specifies the LAN IP address of the server that handles the requests for the
service.
16.1.1 UPnP / NAT-PMP Settings
UPnP and NAT-PMP are network protocols which allow a computer connected to the LAN port
to automatically configure the router to allow parties on the WAN port to connect to itself. That
way, the process of inbound port forwarding becomes automated.
When a computer creates a rule using these protocols, the specified TCP/UDP port of all WAN
connections' default IP address will be forwarded.
Check the corresponding box(es) to enable UPnP and/or NAT-PMP. Enable these features
only if you trust the computers connected to the LAN ports.
When the options are enabled, a table listing all the forwarded ports under these two protocols
can be found at Status>UPnP / NAT-PMP.
17 NAT Mappings
NAT mappings allow IP address mapping of all inbound and outbound NAT’d traffic to and
from an internal client IP address. Settings to configure NAT mappings are located at
Advanced>NAT Mappings.
To add a rule for NAT mappings, click Add NAT Rule.
http://www.peplink.com
115
Copyright @ 2017 Pepwave

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pepwave HD2 and is the answer not in the manual?

Pepwave HD2 Specifications

General IconGeneral
CategoryNetwork Router
ModelPepwave HD2
WAN Ports2
LAN Ports4
Cellular Modems2
Throughput400 Mbps
Load BalancingYes
VPNYes
GPSYes
Wireless Standards802.11a/b/g/n/ac
Ethernet Ports4
FirewallYes
Cellular Connectivity3G/4G LTE
VPN SupportIPsec, PPTP, L2TP

Related product manuals