The Pepwave router monitors outgoing TFTP connections and routes any incoming
TFTP data packets back to the client. Select Enable if you want to enable TFTP
passthrough support.
This field is for enabling the support of IPsec NAT-T passthrough. UDP ports 500, 4500,
and 10000 are monitored by default. You may add more custom data ports that your
IPsec system uses by checking Define custom ports. If the VPN contains IPsec
site-to-site VPN traffic, check Route IPsec Site-to-Site VPN and choose the WAN
connection to route the traffic to.
21.6 GPS Forwarding
Using the GPS forwarding feature, some Pepwave routers can automatically send GPS reports
to a specified server. To set up GPS forwarding, navigate to Advanced>GPS Forwarding.
Check this box to turn on GPS forwarding.
Enter the name/IP address of the server that will receive GPS data. Also specify a port
number, protocol (UDP or TCP), and a report interval of between 1 and 10 seconds.
Click to save these settings.
Choose from NMEA or TAIP format for sending GPS reports.
If you’ve chosen to send GPS reports in NMEA format, select one or more sentence
types for sending the data (GPRMC, GPGGA, GPVTG, GPGSA, and GPGSV).
To Next Page
Loading...
