Pepwave MAX - Restoring Factory Defaults

http://www.pepwave.com
119
Copyright @ 2013 Pepwave
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a Pepwave MAX unit, follow the steps below:
1. Locate the reset button on the front panel of Pepwave MAX unit.
2. With a paper clip, press the reset button and hold it for at least 10 seconds until the unit reboots
itself.
After Pepwave MAX finishes rebooting, the factory default settings will be restored.
Important Note
All previous configurations and bandwidth usage data will be lost after restoring the factory default settings.
Regular backup of configuration settings is strongly recommended.