8.1.3 PPPoE Connection
This connection method is suitable if ISP provides login ID/ password to connect via PPPoE.
This is to substitute the real address in a packet with a mapped address that is
routable on the destination network
IP Address / Subnet
Mask / Default
Gateway
This information is obtained from the ISP automatically.
PPPoE User Name /
Password
Enter the required information in these fields in order to connect via PPPoE to the ISP.
The parameter values are determined by and can be obtained from the ISP.
Verify your password by entering it again in this field.
Service Name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies
the DNS (Domain Name System) Servers to be used when a DNS lookup is routed
through this connection.
Selecting Obtain DNS server address automatically results in the DNS Servers
assigned by the PPPoE server to be used for outbound DNS lookups over the WAN
connection. (The DNS Servers are obtained along with the WAN IP address assigned
from the PPPoE server.)
When Use the following DNS server address(es) is selected, you can put custom
DNS server addresses for this WAN connection into the DNS Server 1 and DNS
Server 2 fields.
To Next Page
Loading...
Need help?
General
