Pepwave MAX User Manual

http://www.pepwave.com
49
Copyright @ 2013 Pepwave
9 Wi-Fi Settings
Wi-Fi settings can be configured at Advanced > Wi-Fi Settings
Wi-Fi AP Radio Settings
Protocol
This option allows you to specify whether 802.11b and/or 802.11g client association
requests will be accepted. Available options are 802.11b/g, 802.11b Only, and
802.11g Only.
By default, 802.11b/g is selected.
Operating Country
This option set the country whose regulations the Pepwave MAX follows.
Channel
This option allows you to select which 802.11 RF channel will be utilized.
Channel 1 (2.412 GHz) is selected by default.
Channel Width
Options Auto (20/40 MHz) and 20 MHz are available. Default is Auto (20/40 MHz),
which allows both widths to be used simultaneously.
Bit Rate
This option allows you to select a specific bit rate for data transfer over the device’s Wi-
Fi network. By default, Auto is selected.
Output Power
This option is for specifying the transmission output power for the Wi-Fi AP.
There are 4 relative power levels available – Max, High, Mid and Low. The actual

Pepwave MAX Specifications

General

Brand	Pepwave
Model	MAX
Category	Network Router
Language	English