Pepwave MAX - Ethernet WAN Configuration

121 pages

To Next Page

To Previous Page

http://www.pepwave.com

8.1 Ethernet WAN

Network > WAN > Click on WAN Details

This will open a screen similar to shown below

Main Page

Default Chapter2
- Table of Contents2
1 Introduction and Scope5
2 Glossary6
3 Product Features7
- Supported Network Features7
- Other Supported Features8
4 Pepwave Max Mobile Router Overview9
- Max 6009
- Max 70011
- Max Hd213
5 Installation15
- Preparation15
- Constructing the Network15
- Configuring the Network Environment16
- Mounting the Unit16
6 Connecting to Web Admin Interface18
7 Configuration of Lan Interface(S)20
- Basic Settings20
- Wi-Fi AP24
8 Configuration of Wan Interface(S)26
- Ethernet Wan27
- Cellular 1 / Cellular 236
- Wi-Fi WAN39
- Wan Health Check44
- Bandwidth Allowance Monitor48
9 Wi-Fi Settings49
10 Bandwidth Bonding Speedfusion Tm52
- Speed Fusion Tm53
- Link Failure Detection57
- Pepwave Max Behind Nat Router58
11 Ipsec Vpn60
- Ipsec VPN Settings60
- Ipsec Status63
12 Management of Outbound Traffic to Wan63
- Outbound Policy63
- Custom Rules for Outbound Policy64
- Expert Mode73
13 Port Forwarding74
- Port Forwarding Service74
  - Ettings76
14 Nat Mappings77
15 Qos79
- User Groups79
- Bandwidth Control80
- Application81
16 Firewall83
- Outbound and Inbound Firewall83
- Intrusion Detection and Dos Prevention87
17 Miscellaneous Settings88
- Pptp Server88
- Service Forwarding89
- Service Passthrough91
18 System Settings92
- Admin Security92
- Firmware Upgrade96
- Time96
- Email Notification97
- Remote Syslog100
- Snmp101
- Incontrol103
- Configuration104
- Reboot105
- Ping Test106
- Traceroute Test107
- Speed Fusion Tm Test107
- CLI (Command Line Interface Support)108
19 Status109
- Device109
- Active Sessions111
- Client List112
- Wins Client113
  - Speed Fusion Tm113
- Upnp / NAT-PMP114
- Event Log115
- Bandwidth116
Appendix A. Restoration of Factory Defaults119

Pepwave MAX - Ethernet WAN Configuration

Table of Contents

Related product manuals