Email Notification Settings
This option is for enabling Email Notification.
If the box Enable is checked, Pepwave MAX sends email messages to a System
Administrator when the WAN status changes, or when new firmware is available.
If the box Enable is not checked, Email Notification is disabled and Pepwave MAX will not
send email messages.
This field is for specifying the SMTP server to be used for sending email. If the server
requires authentication, check the box Require authentication.
Check the box to enable SMTPS. When the box is checked, the next field SMTP Port will
be changed to 465 automatically.
This field is for specifying the SMTP Port number.
By default, this is set to 25; when the SSL Encryption box is checked, the default port
number will be set to 465.
You may customize the port number by editing this field. Click the button Default to
restore to default.
SMTP User Name
/ Password
This setting specifies the SMTP username and password while sending email. These
options are shown only if Require authentication check box is checked in SMTP Server
setting.
This field allows you to verify and confirm the new administrator password.
This setting specifies the sender email address reported by the email messages sent by
Pepwave MAX.
Recipient’s Email
Address
This setting specifies the email addresses to which Pepwave MAX should send the email
messages to. You may enter multiple recipients’ email addresses in this field.
After you have completed the settings, you can click the Test Email Notification button to test the
settings before saving it. After it is clicked, you will see this screen to confirm the settings:
Click Yes to confirm. Wait a few seconds, and you will see a return message and the detailed test result.
To Next Page
Loading...
Need help?
General
