When Use the following DNS server address(es) is selected, you may enter
custom DNS server addresses for this WAN connection into the DNS Server
1 and DNS Server 2 fields.
IP Passthrough
When this IP Passthrough option is active, after the ethernet WAN connection
is up, the router's DHCP server will offer the connection's IP address to one
LAN client. All incoming or outgoing traffic will be routed without NAT.
Regardless the WAN connection's state, the router always binds to the LAN IP
address (Default: 192.168.50.1). So when the ethernet WAN is connected, the
LAN client could access the router's web admin by manually configuring its IP
address to the same subnet as the router's LAN IP address (e.g.
192.168.50.10).
Note: when this option is firstly enabled, the LAN client may not be able to
refresh its IP address to the ethernet WAN IP address in a timely fashion. The
LAN client may have to manually renew its IP address from DHCP server. After
this option is enabled, the DHCP lease time will be 2 minutes. I.e. the LAN
client could refresh its IP address and access the network at most one minute
after the ethernet WAN connection goes up.
Independent from
Backup WANs
If this is checked, the connectio
n will be working independent from other
Backup WAN connections. Those in Backup Priority will ignore the status of
this WAN connection, and will be used when none of the other higher priority
connections are available.
Standby State
This option allows you to choose whether to remain connected when this WAN
connection is no longer in the highest priority and has entered the standby
state. When Remain connected
is chosen, upon bringing up this WAN
connection to active, it will be immediately available for use.
If this WAN connection is charged by connection time, you may want to set this
option to Disconnect so that connection will be made only when needed.
PepVPN may use connected standby WAN for failover if link failure detected
on the higher priority WAN, you can set this option to Disconnect to avoid data
passing through.
Reply to ICMP
PING
If the checkbox is unticked, this option is disabled and the system will not reply
to any ICMP ping echo requests to the WAN IP addresses of this WAN
connection.
Default: ticked (Yes)
Upload Bandwidth
This field refers to the maximum upload speed.
This value is referenced when default weight is chosen for outbound traffic and
traffic prioritization. A correct value can result in effective traffic prioritization
and efficient use of upstream bandwidth.
To Next Page
Loading...
Need help?
General
