9.1.3 PPPoE Connection
This connection method is suitable if your ISP provides a login ID/password to connect via
PPPoE.
PPPoE Settings
Routing Mode
NAT allows substituting the real address in a packet with a mapped address
that is routable on the destination network. By clicking the help icon in this field,
you can display the IP Forwarding option, if your network requires it.
PPPoE Username /
Password
Enter the required information in these fields in order to connect via PPPoE to
the ISP. The parameter values are determined by and can be obtained from
the ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Service Name
(Optional)
Service name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
To Next Page
Loading...
Need help?
General
