corresponding WAN connection will be treated as down after three consecutive
timeouts.
Recovery Retries
Thi
s setting specifies the number of consecutive successful ping/DNS lookup
responses that must be received before the Pepwave router treats a previously
down WAN connection as up again. By default, Recover Retries is set to 3
the default setting, a WA
N connection that is treated as down will be considered as
up again upon receiving three consecutive successful ping/DNS lookup responses.
Automatic Public DNS Server Check on DNS Test Failure
When the health check method is set to DNS Lookup
and health checks fail, the Pepwave router will
automatically perform DNS lookups on public DNS servers. If the tests are successful, the WAN may not
be down, but rather the target DNS server malfunctioned.
You will see the following warning message on
the main page:
9.5 Dynamic DNS Settings
Pepwave routers are capable of registering the domain name relationships to dynamic DNS
service providers. Through registration with dynamic DNS service provider(s), the default public
Internet IP address of each WAN connection can be associated with a host name. With dynamic
DNS service enabled for a WAN connection, you can connect to your WAN's IP address from
the external, even if its IP address is dynamic. You must register for an account from the listed
dynamic DNS service providers before enabling this option.
If the WAN connection's IP address is a reserved private IP address (i.e., behind a NAT router),
the public IP of each WAN will be automatically reported to the DNS service provider.
Either upon a change in IP addresses or every 23 days without link reconnection, the Pepwave
router will connect to the dynamic DNS service provider to perform an IP address update within
the provider’s records.
The settings for dynamic DNS service provider(s) and the association of hostname(s) are
configured via Network>WAN>Details>Dynamic DNS Service Provider/Dynamic DNS
Settings.
To Next Page
Loading...
Need help?
General
