Pepwave Peplink MAX Series User Manual

Encapsulation
Pre-shared Key
This defines the peer authentication pre-
shared key used to authenticate this VPN
connection. The connection will be up only if the pre-
shared keys on each side
match.
Remote
Certificate (pem
encoded)
Available only when X.509 Certificate is chosen as the Authentication
method,
this field allows you to paste a valid X.509 certificate.
Local ID
In Main Mode, this field can be left blank. In Aggressive Mode, if Rem
ote
Gateway IP Address
is filled on this end and the peer end, this field can be left
blank. Otherwise, this field is typically a U-FQDN.
Remote ID
In Main Mode, this field can be left blank. In Aggressive Mode, if Remote
Gateway IP Address is filled on t
his end and the peer end, this field can be left
blank. Otherwise, this field is typically a U-FQDN.
Phase 1 (IKE)
Proposal
In Main Mode
, this allows setting up to six encryption standards, in descending
order of priority, to be used in initial connection key negotiations. In
Aggressive
Mode, only one selection is permitted.
Phase 1 DH
Group
This is the Diffie-
Hellman group used within IKE. This allows two parties to
establish a shared secret over an insecure communications channel. The larger
the group number, the higher the security.
Group 2: 1024-bit is the default value.
Group 5: 1536-bit is the alternative option.
Phase 1 SA
Lifetime
This setting specifies the lifetime limit of this Phase 1 Security Association. By
default, it is set at 3600 seconds.
Phase 2 (ESP)
Proposal
In Main Mode
, this allows setting up to six encryption standards, in descending
order of priority, to be used for the IP data that is being transferred. In
Aggressive
Mode, only one selection is permitted.
Phase 2 PFS
Group
Perfect forward secrecy (PFS) ensures that
if a key was compromised, the
attacker will be able to access only the data protected by that key.
None -
Do not request for PFS when initiating connection. However, since there
is no valid reason to refuse PFS, the system will allow the connection to use
PFS
if requested by the remote peer. This is the default value.
Group 2: 1024-bit Diffie-
Hellman group. The larger the group number, the higher
the security.
Group 5: 1536-bit is the third option.
Phase 2 SA
Lifetime
This setting specifies the lifetime limit of this Phase 2 Security Association. By
default, it is set at 28800 seconds.

Pepwave Peplink MAX Series Specifications

General

Brand	Pepwave
Model	Peplink MAX Series
Category	Network Router
Language	English