Internet IP addresses on which the system should bind. Any access to the
specified WAN connection(s) and IP address(es) will be forwarded to the LAN
host. This option is only available when IP Address is selected in the
Client(s) field.
Note that inbound mapping is not needed for WAN connections in drop-
in mode
or IP forwarding mode. Also note that each WAN IP address can be associated
to one NAT mapping only.
Outbound
Mappings
This setting specifies the WAN IP addresses that should be used when an IP
connection is made from a LAN host to the Internet. Each LAN host in an IP range
or IP network will be evenly mapped to one of each selected WAN's IP addresses
(fo
r better IP address utilization) in a persistent manner (for better application
compatibility).
Note that if you do not want to use a specific WAN for outgoing accesses, you
should still choose default here, then customize the outbound access rule in the
Outbound Policy section. Also note that WAN connections in drop-
forwarding mode are not shown here.
Click Save to save the settings when configuration has been completed.
Important Note
Inbound firewall rules override the Inbound Mappings settings.
To Next Page
Loading...
Need help?
General
